PrintDry Filament Dryer PRO3
Prix
€137,31
Impossible de charger la disponibilité de la réception
Use this text to encourage communication or promote sharing on social networks.
For quality 3D printing
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent is lower.
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
Dryer Temperature Measurement
PrintDry dryer is regulating its temperature by using a close-loop design. When the temperature is above the preset value, the heating unit will be turned off. On the other hand, if the temperature is below the preset value, the heating unit will be turned on. Therefore, the heating unit always have its ON/OFF cycle. When checking the dryer temperature, the following equipment and method are used.
Device: PH-1016U Multi-channel Temperature Measurement Device with T, J, K Type Thermocouples, 0.1℃ temperature resolution and 0.5℃ temperature accuracy.
Spool Adapter included
- 2 metal shafts
- 4 big spool adapters
- 4 small spool adapters
